InfoDepot:Round Downspout Machine / Rolling Shutter Door profile roll forming Machine / Partition Beam Roll forming Machine / Suspended Ceiling clip in Machine

JACK.AIVA

Jiangyin Jack-Aiva Machinery Co.,Ltd
Add: No.44 Lidu city garden, Jiangyin City, Jiangsu China
Tel: +86-510-86251295
Fax: +86-510-86251926
Mobile phone:0086-13915206868
E-mail:rollform@jack-aiva.com
            machinerychina@yahoo.com
Web site: www.rollformingmachine.org

Arc sheet curving machine

Hydraulic Arch crimping machine is used to crimp the formed corrugated sheets into horizontal stripes through hydraulic crimping mold. The distance between each press will decide the curvature of the arch. It is suitable for edge of buildings, parking garage, pavilion and various round roofs of buildings. The Composition of hydraulic Arch crimping machine Crimping main machine and Control panel, this crimping machine can crimp both ends of roofing sheet.

Hydraulic arch crimping machine Main Parameters

ITEM

CONTENT

Formed Profile Type:

Arch Roof panel

Raw material thickness:

0.3-1.0 mm

Corrugated Punching moulds

CR12, HRC55-60

Line speed:

0-10m/min

Feeding mode:

Servo motor, 1kw

Main power:

0.85KW

Hydraulic station power

5.5KW

Electrical control system

PLC

Max. bending angle

120

Machine size

3000 mm×1400mm×1400 mm

We also can do a custom roll forming machine, i.e. We can design the machine according to your specification and profile drawing.

  
This kind corrugated sheet rolling machine can bend riveted corrugated steel tanks and agricultural silos with formed corrugated sheet.
The corrugated sheet bending machine (rolling ) is a three roll double pinch machine specifically designed to roll corrugated sheets of galvanized steel up to 8mm (5/16") thick. Corrugated steel is mainly rolled for tanks, drainage pipes and highway safety rails. There is no standard model of Wella. These are built per customer requirements. The same control options are available with this line as that for the Alpha, Kappa and Beta lines
The machine is basically a three roll double pinch machine. It was specifically designed for bending corrugated materials in steel and aluminum, for different material thickness. Corrugated steel is mainly rolled for tanks, drainage pipes and highway safety rails. There is no standard rolling machine. These are built per customer requirements.
Top and pinching rolls are driven by independent hydraulic motors. Raising and lowering of the pinching roll is also accomplished by hydraulic motor/ worm and pinion gearboxes. The drop-end is manual, the hydraulic version is optional.
Our machine is made to customer requirements of width, wave size, material used, the thickness used and the radii which need to be rolled. So as such, there are no specifications of standard sizes. Please contact with us for optimized selection and discussion well for you and meet your expectations.