InfoDepot:Round Downspout Machine / Rolling Shutter Door profile roll forming Machine / Partition Beam Roll forming Machine / Suspended Ceiling clip in Machine

JACK.AIVA

Jiangyin Jack-Aiva Machinery Co.,Ltd
Add: No.44 Lidu city garden, Jiangyin City, Jiangsu China
Tel: +86-510-86251295
Fax: +86-510-86251926
Mobile phone:0086-13915206868
E-mail:rollform@jack-aiva.com
            machinerychina@yahoo.com
Web site: www.rollformingmachine.org

Decorative Sheet Roll Forming Machine

Decorative sheet metal roll forming machines are mainly for manufacturing ceiling panels and wall panels. With its beautiful surface and simple installation, the aluminum and color coated decorative sheets of ceiling panels and wall panels are widely used in the decorative industry. This kind sheet metal roll forming machine can rollform metal wall sheets which can replace the traditional wooden partition board. The following is the relative introduction for the two kinds sheet metal forming machines.

As ceiling panels and wall panels’ 0.2mm thickness feeding material, the roll forming technology request is high, any mistakes about roll forming technology will cause the problem. This line has the function about embossing pattern on sheets and, two separate panels or one whole pieces panel can be achieved with this line. We are also the few ones have the ability to design such line.
  
Sheet metal roll forming machine for wall panel and ceiling panel Components
Decorative sheet metal roll forming machine is consisted of sheets feeding table, material feeding device, main roll forming machine, embossing device, slitting device, run-out table, electrical control system.
Sheet metal roll forming machine Specification

Line structure

Portal-type frame style,  45# steel

Forming Roller Stations:

25 Stations

Forming Roller shaft:

φ55mm

Forming rollers

GCr15, Quenching, hardness HRC56-62º

Forming Speed:

12 meters / min

Main motor:

11kw

Material of Sheet:

Soft Quality (Annealed) Galvanized or colored Sheets

Sheet Thickness:

0.2mm

Control mode

3xAC380V. 50HZ. (Other system is optional)

Profile sample from Decorative sheet metal roll forming machine
The following profile drawings are some decorative sheets of wall and ceiling panel for your reference, the normal material thickness is 0.4-0.6mm, coated steel sheet or aluminum sheet. Custom style decorative sheets are welcome!

Decorative sheet roll forming machine for wall panel and ceiling panel Components
Decorative sheet roll forming machine is consisted of sheets feeding table, material feeding device, main roll forming machine, embossing device, slitting device, run-out table, electrical control system, hydraulic station system. Etc..
  
Decorative sheet roll forming machine Specification

Line structure

Portal-type frame style,  45# steel

Forming Roller Stations:

15 Stations

Forming Roller shaft:

Φ40mm

Forming rollers

GCr15, Quenching, hardness HRC56-62º

Forming Speed:

12 meters / min

Main motor:

4kw

Material of Sheet:

Soft Quality (Annealed) Galvanized or colored Sheets

Raw material width

67mm, 142mm, 192mm

Sheet Thickness:

0.3mm-0.5mm

Control mode

3xAC380V. 50HZ. (Other system is optional)

Decorative sheet profile for ceiling panel
 
Custom style decorative sheet profiles are welcome!